Hi Vikdal, I will try helping @axe0 with this. These are the results of your last 3 dump files
Please go into BIOS and look for the sata controller and see what it is set to (IDE, AHCI or Raid) and remember it. Also look at you boot configuration and remember what the boot options are. I would like you to look on the main page or the hardware page and tell me the CPU temp, System temp, the +12V, +5V and +3.3V values.
Invalid system memory was referenced. This cannot be protected by try-except.
Typically the address is just plain bad or it is pointing at freed memory.
Arg1: ffff8001efcaaa74, memory referenced.
Arg2: 0000000000000000, value 0 = read operation, 1 = write operation.
Arg3: fffff80279ca2e88, If non-zero, the instruction address which referenced the bad memory
Arg4: 0000000000000002, (reserved)
An exception happened while executing a system service routine.
Arg1: 00000000c000001d, Exception code that caused the bugcheck
Arg2: fffff8006eb4349f, Address of the instruction which caused the bugcheck
Arg3: ffffd0002160cc50, Address of the context record for the exception that caused the bugcheck
Arg4: 0000000000000000, zero.
A kernel component has corrupted a critical data structure. The corruption
could potentially allow a malicious user to gain control of this machine.
Arg1: 0000000000000003, A LIST_ENTRY has been corrupted (i.e. double remove).
Arg2: ffffd00021b4f260, Address of the trap frame for the exception that caused the bugcheck
Arg3: ffffd00021b4f1b8, Address of the exception record for the exception that caused the bugcheck
Arg4: 0000000000000000, Reserved
ERROR_CODE: (NTSTATUS) 0xc0000409 - The system detected an overrun of a stack-based buffer in this application. This overrun could potentially allow a malicious user to gain control of this application.
EXCEPTION_CODE: (NTSTATUS) 0xc0000409 - The system detected an overrun of a stack-based buffer in this application. This overrun could potentially allow a malicious user to gain control of this application.
Next I would like you to set Optimized defaults (usually F5 but could be different on your board.). After setting optimized defaults, go back and set your sata controller to what it was before and do the same with your boot configuration, save and exit.
Once in the OS, right click the start button and select Command Prompt (Administrator) copy/paste this into the command window and press enter. Dism /Online /Cleanup-Image /RestoreHealth Let me know the results of that.