Freezing when playing games

Page 4 of 7 FirstFirst ... 23456 ... LastLast

  1. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #31

    apologies for the delay. I bleaned everything out and had a couple of sucessful sessions at a friends office (2 x 4 hours sessions with no freezes). Came home and froze again, BSOD kept repeating until I manually forced off and turned back on again a few mins later. I disabled everything you asked in taskmanager and msconfig and I again froze. Can I play games in safe mode?

    I was thinking maybe it is an overheating issue? My friends office is a lot cooler than my flat which is on average 24 degrees celcius ambiant temp

    latest logs here

    Attachment 45052
      My Computer


  2. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #32

    3 main differences at my friends office:

    - Ambiant temp is about 18 deg C
    - I'm connected to the internet via the wifi pci card rather than ethernet
    - I'm using a different screen (connected via DVI cable)
      My Computer


  3. Posts : 14,903
    Windows 10 Pro
       #33

    You can't play games in safe mode, because in safe mode there is a minimum of stuff used.

    Try playing games with the wifi card instead of ethernet and see how it goes.
      My Computers


  4. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #34

    As it only crashes during games I wont be able to replicate it during safe mode.

    Crash during game when on wifi, didn't freeze but went straight to BSOD with a new error Attachment 45204message
      My Computer


  5. Posts : 14,903
    Windows 10 Pro
       #35

    The error is 0x124 WHEA_UNCORRECTABLE_ERROR (Windows Hardware Error Architecture)
    This means that there are problems with your hardware, but this error is also caused by overclocking, faulty drivers or BIOS problems.



    STOP 0x124 Troubleshooting

    Read carefully before proceeding.



    warning   Warning
    If you're overclocking your system, revert back to stock clocks now.

    Note   Note
    Test the system once the overclock is removed before continuing with the steps outlined below.


    Part One: CPU Stress Test
    Part Two: MemTest86+ RAM Diagnostic
    Part Three: GPU Stress Test




    ONE

     CPU TEST


    Run Prime95 to stress test your CPU. Prime95 - Stress Test Your CPU - Windows 10 Forums

    warning   Warning
    Your CPU temperatures will rise quickly while under this stress test. Keep a keen eye on them and abort the test if overheating occurs.





    TWO

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking forzero errors here. Even a single error will indicate RAM failure.





    THREE

     GPU TEST


    Run Furmark to stress test your GPU. FurMark - GPU Stress Test - Windows 10 Forums

    Note   Note
    Run Furmark for around 30 minutes.

    warning   Warning
    Your GPU temperatures will rise quickly while Furmark is running. Keep a keen eye on them and abort the test if overheating occurs.


    The problem:
    There is a problem with the fetched data in the level 1 cache when the CPU is trying to execute it.
    Code:
    4: kd> !errrec ffffe000cbc7f028
    ===============================================================================
    Common Platform Error Record @ ffffe000cbc7f028
    -------------------------------------------------------------------------------
    Record Id     : 01d111b809fae720
    Severity      : Fatal (1)
    Length        : 928
    Creator       : Microsoft
    Notify Type   : Machine Check Exception
    Timestamp     : 10/28/2015 19:52:56 (UTC)
    Flags         : 0x00000000
    
    ===============================================================================
    Section 0     : Processor Generic
    -------------------------------------------------------------------------------
    Descriptor    @ ffffe000cbc7f0a8
    Section       @ ffffe000cbc7f180
    Offset        : 344
    Length        : 192
    Flags         : 0x00000001 Primary
    Severity      : Fatal
    
    Proc. Type    : x86/x64
    Instr. Set    : x64
    Error Type    : Cache error
    Operation     : Instruction Execute
    Flags         : 0x00
    Level         : 1
    CPU Version   : 0x0000000000600f20
    Processor ID  : 0x0000000000000004
    
    ===============================================================================
    Section 1     : x86/x64 Processor Specific
    -------------------------------------------------------------------------------
    Descriptor    @ ffffe000cbc7f0f0
    Section       @ ffffe000cbc7f240
    Offset        : 536
    Length        : 128
    Flags         : 0x00000000
    Severity      : Fatal
    
    Local APIC Id : 0x0000000000000004
    CPU Id        : 20 0f 60 00 00 08 08 04 - 0b 32 98 3e ff fb 8b 17
                    00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
                    00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
    
    Proc. Info 0  @ ffffe000cbc7f240
    
    ===============================================================================
    Section 2     : x86/x64 MCA
    -------------------------------------------------------------------------------
    Descriptor    @ ffffe000cbc7f138
    Section       @ ffffe000cbc7f2c0
    Offset        : 664
    Length        : 264
    Flags         : 0x00000000
    Severity      : Fatal
    
    Error         : ICACHEL1_IRD_ERR (Proc 4 Bank 1)
      Status      : 0xb080000000040151
      My Computers


  6. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #36

    Not sure if it has been overclocked, I bought the computer from someone else so not sure what they did to it. I just did a fresh install of the os once I had it. Here is a photo of the bios front page if you can tell anything from that?
    80%x
      My Computer


  7. Posts : 14,903
    Windows 10 Pro
       #37

    There is no photo attached.
    Please try it again.
      My Computers


  8. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #38

    Not sure if it has been overclocked, I bought the computer from someone else so not sure what they did to it. I just did a fresh install of the os once I had it. Here is a photo of the bios front page if you can tell anything from that?

      My Computer


  9. Posts : 38
    Microsoft Windows 10 Home 64-bit 10240 Multiprocessor Free
    Thread Starter
       #39

    also can you recommend any temperature monitoring software?
      My Computer


  10. Posts : 14,903
    Windows 10 Pro
       #40
      My Computers


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 06:03.
Find Us




Windows 10 Forums