Frequent BSODs of unknown reason. Possibly caused by new PC component


  1. Posts : 4
    Windows 10 Pro 64-bit
       #1

    Frequent BSODs of unknown reason. Possibly caused by new PC component


    Hi.

    I have recently upgraded my PC. The upgrade included:

    • A 2GB DDR2 Kingmax RAM stick.
    • A 250GB SATA II Hitachi hard drive, which is a replacement for my old broken hard drive.
    • An NVIDIA GeForce 210.


    I performed a clean install of Windows 7 after the hardware upgrade. After that, I upgraded to Windows 10. Since then, I have been encountering BSODs on a daily basis, even during normal computer use.

    I think that the BSODs were caused by the new parts, and most likely caused by the new RAM stick, since I have not encountered this many BSODs before the hardware upgrade, when I was still using windows XP. Please help me find out the cause for the frequent BSODs.

    I attached the debug file following the posting instructions. Thank you.
      My Computer

  2. axe0's Avatar
    Posts : 14,792
    Windows 10 Pro
       #2

    Hi lunateepsilon,

    Welcome to the 10forums.

    I see you have KMSpico, for what is this used?
      My Computers


  3. Posts : 4
    Windows 10 Pro 64-bit
    Thread Starter
       #3

    I apologize for the late reply. I started this thread, but completely forgot about it.

    KMSpico was used to circumvent Microsoft Office registration check, and none other than that. My copy of windows is genuine, since I acquired the activation key from Dreamspark.
      My Computer

  4. axe0's Avatar
    Posts : 14,792
    Windows 10 Pro
       #4

    Please uninstall Office and remove KMSpico, this to rule out compatibility problems from cracked programs.
      My Computers


  5. Posts : 4
    Windows 10 Pro 64-bit
    Thread Starter
       #5

    Thank you for your reply. Should I re-run the analyzer script and upload the result as well, after uninstalling Office?
      My Computer

  6. axe0's Avatar
    Posts : 14,792
    Windows 10 Pro
       #6

    Only if you get another bluescreen.
    It would not be necessary if you don't get another bluescreen.
      My Computers


  7. Posts : 4
    Windows 10 Pro 64-bit
    Thread Starter
       #7

    Hi again. The problem persists after I have uninstalled Office and KMSpico. I also get BSODs whenever I wake my computer from sleep state.
    Here is the collected data, again.
    Last edited by lunateepsilon; 03 Oct 2015 at 09:10.
      My Computer

  8. axe0's Avatar
    Posts : 14,792
    Windows 10 Pro
       #8

    Please remove Avast using the uninstall instructions
    Code:
    *** WARNING: Unable to verify timestamp for aswSP.sys
    *** ERROR: Module load completed but symbols could not be loaded for aswSP.sys
    Memory problems
    Code:
    Probably caused by : memory_corruption



    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
      My Computers


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 09:37.
Find Us




Windows 10 Forums