Page 7 of 9 FirstFirst ... 56789 LastLast

  1. Joined : Jun 2015
    Posts : 10,908
    Windows 10 Pro / Windows 10 TP / Windows 8.1 Pro / Windows 7 Pro
       04 Sep 2015 #61

    Running memtest for less then 8 passes isn't worth it, because the results aren't conclusive.
    But why did you run memtest? Suspecting memory corruption?

    If everything is fine yes.
      My System SpecsSystem Spec


  2. Joined : Sep 2015
    Posts : 48
    windows 10 pro 64 bits
       04 Sep 2015 #62

    axe0 said: View Post
    Running memtest for less then 8 passes isn't worth it, because the results aren't conclusive.
    But why did you run memtest? Suspecting memory corruption?

    If everything is fine yes.

    will be that if you format windows solves the problems?
      My System SpecsSystem Spec


  3. Joined : Sep 2015
    Posts : 48
    windows 10 pro 64 bits
       05 Sep 2015 #63

    Hi good day, uninstalled avast, updated the killer network and so stopped receiving bsod for 18 hours, but now just received once again a bsod

    you can check again for me, thanks
      My System SpecsSystem Spec


  4. Joined : Jun 2015
    Posts : 10,908
    Windows 10 Pro / Windows 10 TP / Windows 8.1 Pro / Windows 7 Pro
       05 Sep 2015 #64

    I still see the Intel Rapid Storage Technology flagged
    Code:
    *** WARNING: Unable to verify timestamp for iaStorA.sys
    *** ERROR: Module load completed but symbols could not be loaded for iaStorA.sys
    but there is also
    Code:
    IRQL_NOT_LESS_OR_EQUAL (a)
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    If a kernel debugger is available get the stack backtrace.
    Arguments:
    Arg1: 0000000000000088, memory referenced
    Arg2: 0000000000000002, IRQL
    Arg3: 0000000000000000, bitfield :
        bit 0 : value 0 = read operation, 1 = write operation
        bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
    Arg4: fffff80278b2462c, address which referenced memory
    This might have to do with bad memory



    Bsod, irql_not_less_or_equal Diagnostic Test Bsod, irql_not_less_or_equal
     RAM TEST

    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
      My System SpecsSystem Spec


  5. Joined : Sep 2015
    Posts : 48
    windows 10 pro 64 bits
       05 Sep 2015 #65

    axe0 said: View Post
    I still see the Intel Rapid Storage Technology flagged
    Code:
    *** WARNING: Unable to verify timestamp for iaStorA.sys
    *** ERROR: Module load completed but symbols could not be loaded for iaStorA.sys
    but there is also
    Code:
    IRQL_NOT_LESS_OR_EQUAL (a)
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    If a kernel debugger is available get the stack backtrace.
    Arguments:
    Arg1: 0000000000000088, memory referenced
    Arg2: 0000000000000002, IRQL
    Arg3: 0000000000000000, bitfield :
        bit 0 : value 0 = read operation, 1 = write operation
        bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
    Arg4: fffff80278b2462c, address which referenced memory
    This might have to do with bad memory



    Bsod, irql_not_less_or_equal Diagnostic Test Bsod, irql_not_less_or_equal
     RAM TEST

    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
    acabeu to see now, came out a new killer driver today, I'm downloading and completely uninstalled now intel rapid storage (this makes me miss my performance ssd?
      My System SpecsSystem Spec


  6. Joined : Jun 2015
    Posts : 10,908
    Windows 10 Pro / Windows 10 TP / Windows 8.1 Pro / Windows 7 Pro
       05 Sep 2015 #66

    I'm sorry, I don't fully understand "(this makes me miss my performance ssd?"
      My System SpecsSystem Spec


  7. Joined : Sep 2015
    Posts : 48
    windows 10 pro 64 bits
       05 Sep 2015 #67

    axe0 said: View Post
    I'm sorry, I don't fully understand "(this makes me miss my performance ssd?"
    intel rapid storage serves to improve performance ssd?
      My System SpecsSystem Spec


  8. Joined : Jun 2015
    Posts : 10,908
    Windows 10 Pro / Windows 10 TP / Windows 8.1 Pro / Windows 7 Pro
       05 Sep 2015 #68

    krustybbr said: View Post
    intel rapid storage serves to improve performance ssd?
    Intel Rapid Storage is for the hard drives that are connected via the RAID technology.
    If this is not the case, then you should disable it.
      My System SpecsSystem Spec


  9. Joined : Sep 2015
    Posts : 48
    windows 10 pro 64 bits
       05 Sep 2015 #69

    axe0 said: View Post
    Intel Rapid Storage is for the hard drives that are connected via the RAID technology.
    If this is not the case, then you should disable it.
    uninstalled this driver (Intel Rapid Storage Technology), I installed the killer driver who came out today as well.
    I hope soon solve the problem, you recommend a clean install of windows before testing memory ram?

    Thank you,
    Leonardo
      My System SpecsSystem Spec


  10. Joined : Jun 2015
    Posts : 10,908
    Windows 10 Pro / Windows 10 TP / Windows 8.1 Pro / Windows 7 Pro
       05 Sep 2015 #70

    A clean install won't work when RAM is the problem.
    So, it doesn't really matter, but I wouldn't.

    When a new version of a driver comes it, it is smart to wait a few days before installing the new version because of some possible problems that are usually fixed within a few days.
      My System SpecsSystem Spec


 
Page 7 of 9 FirstFirst ... 56789 LastLast


Similar Threads
Thread Forum
Bsod irql_not_less_or_equal
Upgrade to Windows 10 yesterday, from Windows 7 Pro. After a couple of hours of usage, I started getting BSODs, more specifically IRQL_NOT_LESS_OR_EQUAL. I decided to reset the system, but the same problem keeps occurring. I'm thinking it's a...
BSOD Crashes and Debugging
Bsod:- irql_not_less_or_equal
BSOD occurs at shutdown:- IRQL NOT LESS OR EQUAL file path: C:\Windows\system32\drivers\clfs.sys
BSOD Crashes and Debugging
Solved BSOD random "irql_not_less_or_equal"
Hello there 10 forum. from about 3 days I have frequently BSOD crashes showing irql_not_less_or_equal error. I have no idea why is it happening. It happens when I am watching streams, playing games, etc. :__; Here is the file: 34829 Thanks...
BSOD Crashes and Debugging
Irql_not_less_or_equal
heya i upgraded to windows 10 yesterday and now i keep getting a blue screen. IRQL_NOT_LESS_OR_EQUALI think this is because of a bad driver? any ideas on how i can fix this. I already reinstalled my graphic card drivers with no succes.:(
BSOD Crashes and Debugging
Solved BSOD - usbehci.sys - IRQL_NOT_LESS_OR_EQUAL
I have already had 7 of them, just got one when trying to post this. I suspect my USB sound card. So far they have happened only in Windows, not in games, when listening to the music on youtube or via Radiosure, sometimes I was not even at PC, so I...
BSOD Crashes and Debugging
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 17:53.
Find Us
Twitter Facebook Google+



Windows 10 Forums