Multiple BSOD crashes during everyday use

Hi Alphalele,

Welcome to 10Forums

Due to the variation of the crashes, and a status error code I noticed with the faulty_hardware_corrupted_page which indicates a system file has been corrupted, I am going to post a few suggestions for diagnosis to see the current state of your Windows, the memory and hard drive. If you have done the verification of the system files for Windows, please let me know and ignore it. For the memory and hard drive, I would like to see screenshots/photos because I need to some details about the tests.

To not overwhelm you I will provide 1 diagnostic test at a time.

Diagnostics Test

 System File Check

Please try following:

• Open an admin command prompt
• Copy/paste "sfc /scannow" (without quotes) and press enter
• When it is finished reboot your system
• Open again an admin command prompt
• Enter sfc/scannow again

If sfc/scannow says "Windows Resource Protection found corrupt files but was unable to fix some of them" after the second SFC, please upload the cbs.log file located at %systemroot%\Logs\CBS\, if the file is too large try a 3rd party uploader like dropbox, onedrive, google drive, mediafire etc.
System File Check(SFC a.k.a. Windows Resource Protection) needs to have your system rebooted in order for sfc to try to fix the problems that it finds.

Make a photo of SFC and post it.

Diagnostics Test

 HDD TEST

   Note

Run the tests on all hard drives/partitions!

Please run HDTune first, in the order posted!

Run HDTune to

• check the health,
• scan for errors, no quick scan but full scan
• run a benchmark.

It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following

• the health,
• the error scan,
• the benchmark incl. following
  
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

Run SeaTools DOS to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums
Run the long test.

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Make a photo of the result and post it.

Run chkdsk
Disk Check - Windows 7 Help Forums
Use option TWO with parameter /r
Upload the chkdsk log Check Disk (chkdsk) - Read Event Viewer Log - Windows 7 Help Forums

Pleaes post the actual log of chkdsk from the eventviewer.

Press Y to schedule the chkdsk, save any work and reboot the system.
Please note that this may take some time, even with an SSD. On my SSD it takes roughly 20 minutes.
After chkdsk is finished your system will automatically reboot, after Windows is back up please upload the log from the eventviewer.

Chkdsk might look like it is hanging at around 12-20%, it is not. Chkdsk is from that point scanning the used and free space for issues. When the space scanning part is finished, chkdsk will either very quickly display 100% or reboot immediately.
Please do NOT interrupt this process.

Apologies for not clarifying this earlier.

Please run memtest86.When MemTest86 is booted, press T to access the test selection and change 4 passes to 8 passes.How to boot MemTest86: PassMark MemTest86 - Memory Diagnostic Tool - Technical Information