Persistent BSOD ntoskrnl.exe

Yes it does and thanks. I'll dive into the manual this weekend, create a strategy based on your suggestion and report back when appropriate. Thanks much.

Okydoky I've been running since this morning on half RAM and so far so good. If I'm BSOD free tomorrow morning then there's a good chance it's the other group of RAM and I'm thinking 48hrs (or essentially Tue. morning) of normal use without BSOD should be a good indication of RAM health (assuming it's the RAM that's causing the BSODs). Does this seem reasonable? If the current group of RAM makes it to Tuesday is it safe to assume that the other batch of RAM is faulty? Finally should I test the other bad group to confirm it's bad?

That sounds reasonable. I'd suggest making sure you're using CINEMA 4D.exe at some point as that seemed to show up quite often as the owner of the thread that crashed in the dump files you made available previously.

I can't say it definitively means there's a bad DIMM in the other group of DIMMs but it very well might. The only reliable way to check is to swap them out and try the same test, in my opinion. Things could get complicated if neither group causes the system to become unstable but we'll cross that bridge if we come to it.

No BSODs as of this morning and now going about a regular work day with fingers crossed.

Okydoky we made it to Tuesday morning. As I'm in the middle of a project now I think I'm going to try the other RAM group on Friday evening. This up-time is nice... :)

Haven't noticed a difference at all. I invested in the full 128gb for multitasking (running After Effects and C4D concurrently) as well as longer RAM previews in AE.

Up-time is addictive. The project I'm currently on is currently ramping into high gear and given that I havn't had nary a single BSOD since the extraction I feel I need to continue working as is until my project wraps. Thanks for sticking with me and I'll be back in a couple of weeks.

No worries. I'm glad the system is solid for you in the current configuration. Thank you for letting us know.

I'm back and I switched RAM sets. Interestingly enough I had to replace my Liqtech 360 because the pump died. I replaced it with the Liqtech II 280 and at almost 24 hrs of uptime I'm getting decent idle temps at approx. 30degC. More importantly (and frustratingly) no BSODs. This is also after initiating the same GPU render which was what I thought was originally causing the BDODs. Does this indicate my processor? Should I fire up Prime?