New Macrium Reflect Updates

Josey Wales said:

I made one and also rescue Media, it seems there is an issue with drive cloning.??

I'll just wait for the updated fix for the update Josey.....

OldMike65 said:

I'll just wait for the updated fix for the update Josey.....

Yea if there is one. I checked the update and so far nothing. I suppose I could use the rescue media from 3196 to go back to it but I don't want to.

Josey Wales said:

Yea if there is one. I checked the update and so far nothing. I suppose I could use the rescue media from 3196 to go back to it but I don't want to.

Don't worry about it right now, got to have patience Josey. Think your backup image you made with this new update will be fine.

meebers said:

I have one lifetime and1 yr (3pc) licenses using version 3.5.1. If I upgraded to ver 7, would that screw my license's on either license type

I started with v6. Did not know MR had a 3,5.1.

You can use the Free version. but you probably would have to pay to update to the paid a little.

Apologies for the confusion. v7.13303 was pulled due to an inconsistency in clone target disk detection. v7.1.3307 has now just been released. .

Kind Regards

Nick - Macrium Support
@Cliff S

Josey Wales said:

Apologies for the confusion. v7.13303 was pulled due to an inconsistency in clone target disk detection. v7.1.3307 has now just been released. .

Kind Regards

Nick - Macrium Support
@Cliff S

Thanks, all back to normal now.

This just keeps getting better



And now this one



Well at least I have Revo Uninstaller!

Bug Fixes v7.1.3307 - 2nd July 2018

SQL Backup failure if TLS 1.0 is disabled
SQL DB authentication would fail if TLS 1.0 was disabled and TLS 1.2 enabled. This has been resolved.

Clone and restore error message improvements
When a clone or restore failed the error messages could display incorrect or cryptic error text. Typically you may have seen 'Access Denied' for a failure, however the true cause of the problem would likely have been different. The error text now displays the initial and correct reason for the failure.

Clone target disk could not be found
A clone could fail with an unidentified target disk. This has been resolved.

MIG installation
Macrium Image Guardian could turn off after a reboot if installed for a single user as opposed to the default 'All Users'. This has been resolved.

So it was only limited to problems with cloning ? I made a valid backup with 303 and only now updated to 307.