Macrium Redeployment not able to boot windows on different hardware

I have Win 7 64 bit on 8 years old AMD. I am redeploying it on i3 4 th gen Asus Motherboard H81 . Everything goes smooth. Redeployment says that it has found driver for SATA AHCI and it will load when Window will boot.
But Windows not booting on i3. The Black Screen comes where at the bottom message comes, something like press DeL or F2 then it goes and comes again and again.
I can try to reinstall afresh also but I want to know why it is happenning and can anything be done. OR it will not be successful because there is too much difference in Motherboard.

thomaseg1 said:

Off the top of my head
Was the bios secure boot turned on or off in the old computer?
The new computer has to match that.
The old computer you say is Amd is the new Amd or Intel?

The new one is Intel. I do not remember about the secure boot in old pc. Old pc was not UEFI.

thomaseg1 said:

Then you will have to turn off Uefi in the new one

UEFI is turned off. Legacy is on.

thomaseg1 said:

Well I am out of ideas, sorry I couldn't help.

Thanks for trying to help.

try booting from the Macrium recovery usb, then select 'Fix Windows boot problems' from the Restore Tasks.

Bree said:

try booting from the Macrium recovery usb, then select 'Fix Windows boot problems' from the Restore Tasks.

Fix boot is asking to select partition your pc should boot from.

There is already tick mark in front of System Reserved Partition.
Window is installed on C Partition.
So where to put tick mark.
System Reserved or C

- - - Updated - - -

sam9 said:

Fix boot is asking to select partition your pc should boot from.

There is already tick mark in front of System Reserved Partition.
Window is installed on C Partition.
So where to put tick mark.
System Reserved or C

I went for the Rescue Choosen path i.e System Reserved.
After restart, first time I saw Windows Logo but then came Blue Screen of death.
Pl advise.

sam9 said:

I went for the Rescue Choosen path i.e System Reserved.
After restart, first time I saw Windows Logo but then came Blue Screen of death.
Pl advise.

The first screen should have show it had found your Windows installation, like this....



...then when you click Next you should see a list of possible options. You should tick just the C: drive where your Windows is installed...



...then accept the defaults on the subsequent screens.



I got these screenshots just now by going through the steps on a UEFI PC that was set for Legacy boot, just as yours is. Windows booted successfully after the repairs, but then it was already booting OK before I started.