Image restoration question using Reflect


  1. Posts : 1,020
    Windows 10 Pro 20H2 19042.572
       #1

    Image restoration question using Reflect


    A couple of questions about restoring images with Macrium Reflect.

    I decided to reconfigure my system. This is what my system looked like: C: drive = 250gb SSD, D: drive 250gb spinner, G70gb) & S200gb) drives on a 270gb spinner.
    This is what I wanted it to look like: c: drive 250gb SSD, D333gb) G10gb) S100gb) drives on a 500gb SSD.

    What I did:

    Created image backups of D:, G:, and S:

    R&R the drives

    Restored D:, Then resized the D: partition to 333gb with Aomei Partition wizard and created the 2 remaining partitions.

    When I went to restore G:, it would only allow me to overwrite the entire 500gb SSD. I said no, maybe I shouldn't create the empty partitions, so I removed them and tried it again. It again only wanted to overwrite the entire disk.

    My question is What should of I done to restore the images to the sizes that I wanted them to be ?

    All suggestions will be appreciated.
      My Computers


  2. Posts : 1,620
    Windows 10 Home
       #2

    There should be a sub-menu that allows you to specify the target partition and the size of said target partition. I'll listen in and learn alongside you, I need to relearn where that sub-menu is. I'm using MR7, however. I think MR6 & MR7 have that same sub-menu.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 07:41.
Find Us




Windows 10 Forums