New
#1
HD Clone to SSD problems in 11082
I recently installed the 11082 update to Windows 10. On my machine I have a 500GB (120GB used) hard drive and a 120GB SSD. The hard drive installation seems to be working fine. Every time I go through the clone process to the SSD using Macrium Reflect 6.1.1000 the cloning process ends fine. I then change the boot order and reboot from the SSD and that works fine initially but the second time I boot from the SSD it says Windows has a problem and cannot start or repair itself. I have tried this multiple times and the second boot from the SSD always fails even though I do nothing to the system between the first SSD boot and the second.
So the first time it boots up from the Windows 10 11082 SSD it must detect or change something that corrupts the system. The thing is I can switch back to the hard drive and it continues to boot just fine into 11082. I have even tried disconnecting the HD before the SSD boots and it does the same thing (fails) on the second SSD boot. I even tried doing a backup after the first SSD boot and then trying to restore it but that fails when it reboots so the system seems already corrupted at that point.
I have been using this update scenario (first HD then SSD) for quite some time on this machine and this is the first build where I cannot switch over to the cloned SSD.
Has anyone else experienced this issue in 11082 or better yet resolved the problem?