New
#1
Switched (cloned) to new hard drive; only boots w/ old one plugged in
Hi,
I just bought a new 2tb HDD to replace my ancient 160gb one. Since I'm overall very happy w/ my Windows 10 installation I decided to clone instead of install fresh and used Macrium Reflect to clone the drive. Upon switching from the old to the new one, I was disappointed to encounter a bluescreen boot error, after the Windows logo and spinning symbol had been displaying for a few seconds: Error 0xc00000e, system_service_exception. Trying to boot into any variety of safe mode gives the same result. I didn't think this was an MBR issue based on how far into the boot process it happened, but I tried repairing / rebuilding the MBR anyway and it didn't change the problem.
The weird thing is that when I plugged in my old drive to boot to it and troubleshoot, my system actually booted to the new, clone drive, and it works perfectly - exactly like the old one did - but it only works like this with the old drive plugged in.
See this image: http://imgur.com/YVhKAqX
Obviously the new drive is the larger C:, which is correctly flagged as system, active, primary, etc. D: is the old drive. (Before I cloned and switched, the old drive was C.)
I suspect the issue might have to do with the un-lettered 450mb recovery partition I didn't clone over from the old hard drive, but I'm not sure. Everything looks to me like the C: drive should boot on its own, but it just doesn't. I'd appreciate any insight into this. Thank you!