New
#1471
the pi zero is so hard to get cause it goes out of stock fast
My 3b is in that custom PIBOW case connected to my Pi foundation display. The display board is all covered up and hidden away by bottom piece of a PIBOW case. Its the ribbon cable going to the DSI port that's the pain. At some point I'm going to order a longer cable. It's the same cable the Pi camera board uses. There are lots of longer cables for that out there.
I bought a long cable I think its 12" but maybe 14",i might use it ,I had a plan for it when I order it but that plan changed ,,and might change again ,lol
I bet, if you took your dremel, and turned that flower petal opening into a nice round open hole, it would be a lot quieter. I cut the stock fan grills out on my PC cases so its a nice open hole. Then mount one of those chrome fan grills in its place. Much better air flow and a lot quieter. In your case you'd just have to watch where you out your fingers afterward. Finding a little chrome grill that small might be hard.
EDIT, you could likely make a grill from and old wire coat hanger though.
If you look at the pictures in this post, The Raspberry Pi Thread [2] you'll see what I mean about the display cable being in the way of the SD card slot. especially the last picture at the bottom. And why it would be a pain to have to reconnect it to the display board if it gets disconnected by accident.