No driver flagged when a crash is caused by driver verifier often results in hardware problems.
Based on the crash type, result of driver verifier and below (write access fault), I'd say your memory is faulty.
You could test your memory using MemTest86+ to verify it, although it isn't always correct when it shows no errors, read carefully the instructions if you do.
2: kd> !pte 8000000000900121
PXE at FFFFF6FB7DBED000 PPE at FFFFF6FB7DA00000 PDE at FFFFF6FB40000020 PTE at FFFFF68000004800
contains 07B000017A3FE867 contains 0000000000000000
pfn 17a3fe ---DA--UWEV not valid
WARNING: noncanonical VA, accesses will fault !
Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums
MemTest86+ needs to be run for at least 8 complete passes
for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero
errors here. Even a single error will indicate RAM failure.
If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
If errors show up and you see them a lot later, no problem, the errors don't affect the test.