I hope this says enough
Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck A, {0, 2, 0, fffff80373cda494}
*** WARNING: Unable to verify timestamp for V0060Vid.sys
*** ERROR: Module load completed but symbols could not be loaded for V0060Vid.sys
An invalid memory address was being accessed when the priority (IRQL) was too high, for normal execution it should be 0, higher is meant for either Windows mechanism or hardware
Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
IRQL_NOT_LESS_OR_EQUAL (a)
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arguments:
Arg1: 0000000000000000, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000000, bitfield :
bit 0 : value 0 = read operation, 1 = write operation
bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff80373cda494, address which referenced memory